Power Engineering, Metallurgic and Chemical Machinery (05.04.00)

Number of articles on this topic: 22

Article List:

2016, №2
THERMAL EFFICIENCY OF FORMATION OF THE SEAM AT ELECTRON BEAM AND SOLID-PHASE WELDING

,

12-14
MODERN WAYS OF CREATION THE PATTERN OF ROTATING PARTS AND FLOW PATHS AS APPLIED TO MULTIROWED PUMPS FOR FEED SYSTEMS ON THERMAL POWER PLANT5-11
2016, №3
THE IMPROVEMENT OF THE VOLUMETRIC HYDRAULIC ACTUATOR WITH FREQUENCY CONTROL DYNAMICS BY MEANS OF ADDITIONAL SPEED-INVERSE CONNECTION

,

5-15
2017, №2
Comparison of Variable Modes of the Last Stages in Half- and Full-Speed Turbines for NPPs6-11
Factors Causing Reduction in the Bearing Capacity of Hydraulic Turbine Structural Elements in the Course of Long-Term Operation12-19
2017, №3
The Influence of Injected Steam Temperature on the Liquid Phase Characteristics Downstream of an Isolated Nozzle Vane Cascade

,

,

,

,

,

,

,

6-12
2017, №4
Non-Vortex Superfluid Flow of Helium-II in the Channel with a Porous Insert

,

,

8-14
2017, №5
A Procedure for Determining the Operating Modes of Electron Beam Wire Feed Layer-Wise Deposition for Additive Manufacturing

,

,

8-14
2017, №6
Analyzing the Applicability of Procedures for Calculating the Coefficient of Heat Transfer in Boiling of Multicomponent Working Fluids

,

106-112
The Dynamic Characteristics of a Frequency-Controlled Volumetric Fluid Servodrive

,

113-124
2018, №1
A Comparative Analysis of Involute and Conventional Inlets for Centrifugal Pumps with a Passing-Through Shaft

,

8-15
2018, №2
Experimental Study of the Working Process in a Pilot Sample of an Axial Pump with Three-Row Multiplane Flow Paths 8-13
2018, №3
Modeling Wet-steam Flows in the Flow Paths of Steam Turbines

,

,

,

,

,

8-20
2018, №4
Studying the Integral Characteristics of a Cooling System Equipped with a Thermoelectric Module

,

8-16
Pump-Controlled Hydraulic Drives with Frequency Control and a Few Power Channels

,

17-27
Selecting the Computation Model Boundaries in Performing Combined Experimental and Numerical Confirmation of NPP Branched Pipework Seismic Stability

,

,

,

,

28-35
2018, №5
An Analysis of Factors Causing Poor Efficiency of the K-200-130 Steam Turbine Low-Pressure Cylinder

,

,

8-15
2018, №6
Assessing the Bearing Capacity of Hot-Metal Crane Ropes Based on Laboratory Thermal Test Data

,

,

,

,

12-18
Improving the Aerodynamic Performance of Wide-Angle Flat Diffusers

,

,

19-26
Using a Robotic System in Repairing Steam Turbine Rotor Blades

,

27-32
Development and Construction of Domestic High-Efficient Small-Capacity Power Equipmen

,

,

,

33-42
A Procedure for Calculating the Low-Temperature Installation Start-up Time8-11