An Analysis of Factors Causing Poor Efficiency of the K-200-130 Steam Turbine Low-Pressure Cylinder
DOI:
https://doi.org/10.24160/1993-6982-2018-5-8-15Keywords:
Baumann stage, upper and lower tiers, losses due to blade height to mean diameter ratio and overlappingAbstract
Designing a low-pressure cylinder (LPC) with a one-and-a-half steam exhaust from it is the only way in which a larger steam flowrate can be passed to a condensing steam turbine’s condenser without increasing the length of the turbine last-stage blades. For implementing this idea, K. Baumann has developed a special next-to-last two-tier stage, which diverts part of the steam passing through the stage’s upper tier directly into the condenser in bypass of the last-stage bucket. In the former Soviet Union, this solution was implemented in a number of medium- and high-pressure turbines, as well as in the K-200-130 turbine produced by the Leningrad Metal Works (LMZ). However, field experience gained from operation of this turbine, as well as special investigations, showed that the LPC fitted with the Baumann stage had poor efficiency, and during the subsequent modernizations the Baumann stage was removed from the K-200-130 turbine’s LPC flow path. Factors that have caused dramatic degradation of the cylinder efficiency are analyzed. It is shown that the factors relating directly to the Bauman stage that were considered in the scientific literature could not play the key role in degrading the stage efficiency and, accordingly, in affecting the cylinder efficiency. It has been shown from the performed analysis that poor efficiency of the LPC equipped with the Baumann stage is not due to the stage itself, but due to the conditions of steam admission to it and to the K-200-130 LMZ turbine last stage. As a result, two out of four (in total) stages contained in this cylinder operate with dramatically degraded efficiency. These design drawbacks removed, the Baumann stage can well be used to increase the maximum possible steam passage through the LPC.
References
2. Fukuda H., Ohyama H., Miyawaki T., Mori K., Kadoya Y., Hirakawa Y. Development of 3,600-rpm 50-inch/3,000-rpm 60-inch Ultra-long Exhaust end Blades // Mitsubishi Heavy Industries Techn. Rev. 2009. V. 46. No. 2.
3. Shigeki Senoo e. a. Development of Titanium 3600- rpm- 50-inch and 3000-rpm-60-inch Last Stage Blades for Steam Turbines // Intern. J. Gas Turbine, Propulsion and Power Syst. 2014. V. 6. No. 2. Pp. 9—16.
4. Петреня Ю.К. и др. Перспективы создания быстроходных паротурбинных установок мощностью 1500 МВт и выше // Труды ЦКТИ. 2002. Вып. 283. C. 12.
5. Недавний В.В., Ласкин А.С. Тихоходная паровая турбина класса 1200 МВт с применением ступени Баумана // Труды Академэнерго. 2014. № 1. C. 51—61.
6. Недавний В.В., Ласкин А.С. Применение цилиндров повышенной пропускной способности для паровых турбин большой мощности // Труды Академэнерго. 2014. № 2. С. 43—52.
7. Филиппов Г.А., Назаров О.И., Беляев Л.А. Пути совершенствования паротурбинных установок АЭС // Известия Томского политехн. ун-та. 2012. Т. 320. № 4. С. 5—9.
8. Дейч М.Е., Трояновский Б.М. Исследование и расчеты ступеней осевых турбин. М.: Машиностроение, 1964.
9. Дейч М.Е., Филиппов Г.А., Лазарев Л.Я. Атлас профилей решеток осевых турбин. М.: Машиностроение, 1965.
10. Таушканова В.Б. Испытания выхлопных патрубков и осевых компрессоров // Исследование элементов паровых и газовых компрессоров. М.: Машгиз, 1960. С.107—116.
11. Трояновский Б.М., Филиппов Г.А., Булкин А.Е. Паровые и газовые турбины атомных электростанций. М.: Энергоатомиздат, 1985.
12. Дейч М.Е. Газодинамика решеток турбомашин. М.: Энергоатомиздат, 1996.
13. Топунов А.М., Тихомиров Б.А., Косарев А.В., Шекун Г.Д. Управление потоком в проточной части турбин. Владивосток: Изд-во Дальневост. ун-та, 1994.
---
Для цитирования: Зарянкин А.Е., Осипов С.К., Крутицкий В.И. Анализ причин низкой экономичности цилиндра низкого давления паровой турбины К-200-130 // Вестник МЭИ. 2018. № 5. С. 8—15. DOI: 10.24160/1993-6982-2018-5-8-15.
#
1. Tanuma T. Development of Last-Stage Long Blades for Steam Turbines. Advances in Steam Turbines for Modern Power Plants. Tokio: Woodhead Publ., 2016: 279—305.
2. Fukuda H., Ohyama H., Miyawaki T., Mori K., Kadoya Y., Hirakawa Y. Development of 3,600-rpm 50-inch/3,000-rpm 60-inch Ultra-long Exhaust end Blades. Mitsubishi Heavy Industries Techn. Rev. 2009;46;2.
3. Shigeki Senoo e. a. Development of Titanium 3600- rpm- 50-inch and 3000-rpm-60-inch Last Stage Blades for Steam Turbines. Intern. J. Gas Turbine, Propulsion and Power Syst. 2014;6;2:9—16.
4. Petrenya Yu.K. i dr. Perspektivy Sozdaniya Bystrokhodnykh Paroturbinnykh Ustanovok Moshch- nost'yu 1500 MVt i Vyshe. Trudy TSKTI. 2002;283:12.(in Russian).
5. Nedavniy V.V., Laskin A.S. Tikhokhodnaya Parovaya Turbina Klassa 1200 MVt s Primeneniem Stupeni Baumana. Trudy Akademenergo. 2014;1:51—61. (in Russian).
6. Nedavniy V.V., Laskin A.S. Primenenie Tsilindrov Povyshennoy Propusknoy Sposobnosti dlya Parovykh Turbin Bol'shoy Moshchnosti. Trudy Akademenergo. 2014;2:43—52. (in Russian).
7. Filippov G.A., Nazarov O.I., Belyaev L.A. Puti Sovershenstvovaniya Paroturbinnykh Ustanovok AES. Izvestiya Tomskogo Politekhn. Un-ta. 2012;320;4:5—9. (in Russian).
8. Deych M.E., Troyanovskiy B.M. Issledovanie I Raschety Stupeney Osevykh Turbin. M.: Mashinostroenie, 1964. (in Russian).
9. Deych M.E., Filippov G.A., Lazarev L.Ya. Atlas Profiley Reshetok Osevykh Turbin. M.: Mashinostroenie, 1965. (in Russian).
10. Taushkanova V.B. Ispytaniya Vykhlopnykh Patrubkov i Osevykh Kompressorov. Issledovanie Elementov Parovykh i Gazovykh Kompressorov. M.: Mashgiz, 1960: 107—116. (in Russian).
11. Troyanovskiy B.M., Filippov G.A., Bulkin A.E. Parovye i Gazovye Turbiny Atomnykh Elektrostantsiy. M.: Energoatomizdat, 1985. (in Russian).
12. Deych M.E. Gazodinamika Reshetok Turbomashin. M.: Energoatomizdat, 1996. (in Russian).
13. Topunov A.M., Tikhomirov B.A., Kosarev A.V., Shekun G.D. Upravlenie Potokom v Protochnoy Chasti Turbin. Vladivostok: Izd-vo Dal'nevost. Un-ta, 1994. (in Russian).
---
For citation: Zaryankin A.E., Osipov S.K., Krutitsky V.I. An Analysis of Factors Causing Poor Efficiency of the K-200-130 Steam Turbine Low-Pressure Cylinder. MPEI Vestnik. 2018;5:8—15. (in Russian). DOI: 10.24160/1993-6982-2018-5-8-15.
